Unix‎ > ‎Solaris‎ > ‎Solaris man pages‎ > ‎1‎ > ‎


     posttek - PostScript translator for Tektronix 4014 files

     posttek [-c num] [-f name] [-m num]  [-n num]  [-o list]  [-
     p mode] [-w num] [-x num] [-y num] [file...]


     The posttek filter translates Tektronix 4014 graphics  files
     into  PostScript and writes the results on the standard out-
     put. If no files are specified, or if - is one of the  input
     files, the standard input is read.

     -c num   Print num copies of each page. By default, only one
              copy is printed.

     -f name  Print text using font name. Any PostScript font can
              be used, although the best results will be obtained
              only with constant width fonts. The default font is

     -m num   Magnify each logical page by the factor num.  Pages
              are  scaled  uniformly  about  the origin which, by
              default, is located at the center of each page. The
              default magnification is  1.0.

     -n num   Print num logical pages on  each  piece  of  paper,
              where  num can be any positive integer. By default,
              num is set to  1.

     -o list  Print pages whose numbers are given in  the  comma-
              separated  list. The list contains single numbers N
              and ranges N1 - N2. A missing N1 means  the  lowest
              numbered  page, a missing N2 means the highest. The
              page range is an expression of logical pages rather
              than  physical sheets of paper. For example, if you
              are printing two logical pages to a sheet, and  you
              specified  a  range  of 4, then two sheets of paper
              would print, containing four page layouts.  If  you
              specified a page range of  3-4, when requesting two
              logical pages to a sheet; then only page 3 and page
              4 layouts would print, and they would appear on one
              physical sheet of paper.

     -p mode  Print files in either portrait or  landscape  mode.
              Only  the  first  character of mode is significant.
              The default mode is landscape.

     -w num   Set the line width used for graphics to num points,
              where  a point is approximately 1/72 of an inch. By
              default, num is set  to   0  points,  which  forces
              lines to be one pixel wide.

     -x num   Translate the origin num inches along the  positive
              x  axis. The default coordinate system has the ori-
              gin fixed at the center of the page, with  positive
              x to the right and positive y up the page. Positive
              num moves everything right. The default  offset  is
              0.0 inches.

     -y num   Translate the origin num inches along the  positive
              y  axis. Positive num moves everything up the page.
              The default offset is  0.0.

     The following exit values are returned:

     0               Successful completion.

     non-zero        An error occurred.



     See attributes(5) for descriptions of the  following  attri-

    |       ATTRIBUTE TYPE        |       ATTRIBUTE VALUE       |
    | Availability                | SUNWpsf                     |

     download(1), dpost(1), postdaisy(1), postdmd(1),  postio(1),
     postmd(1), postprint(1), postreverse(1), attributes(5)

     The default line width is too small  for  write-white  print
     engines, such as the one used by the PS-2400.

Man pages from Solaris 10 Update 8. See docs.sun.com and www.oracle.com for further documentation and Solaris information.